May 262010
The parts for the 1/288 Nexus model were received from the “printer,” cleaned up, modified a tad, and shipped on. Now it’s up to the molder/caster. Photos of the actual master parts below… note that some parts will need to be duplicated several times per kit. Not shown here is the display stand.
4 Responses to “Nexus model is out the hatch”
Sorry, the comment form is closed at this time.
Where exactly do the plumbing lines go?
They connect the LOX tanks, as visible here:
http://up-ship.com/blog/blog/wp-content/uploads/2009/09/nexstand3.jpg
Please tell me you are joking about the Vac Formed engine bells. Thats just cruel! 😛
No other way to cost effectively make 24 small (about 1/4 inch wide) nozzles. Seems a hell of a lot easier to me than resin nozzles.