So it has been a little bit of a while. Been busy, and lately I’ve been ill (influenza B). But the illness is finally fading and the busyness may be tapering a bit. So here’s a recent product of slow progress: the 3D printed bits of a 1/18 Project Pluto nuclear ramjet missile. Much of it is fiber-printed, with smaller parts resin printed. Why does it exist? Because I want one. But also because I hope other people may want one (or more). As shown here it’s fairly basic; nose cone and midsection are printed as single pieces, tail section left & right halves. A basic TORY nuclear reactor is included; it’s visible through the nozzle but not so much through the serpentine inlet. But if displayed as a cutaway, it should be pretty effective. If I go ahead with a production version, the midsection will be split left and right, with visible equipment including weapons bays. Who might be interested in this as a kit? Printed and ready for sanding (LOTS of sanding) and assembly, I’m guessing something like $200 plus shipping. A fully completed display piece would be rather more. Going to experiment some with getting a good golden surface. If interested in joining a list, send an email to: 
Not shown are the 1/144 “Big Onion” SPS launching SSTO and the 1/1 M388 “Davy Crockett” warhead. Both of those are done and being painted.
